Tacho Pro 2008 Dash Programmer -OBDexpress.co.uk: 3 Steps to change BMW E87 Mileage With Tacho Pro 2008?

Purpose:BMW 1series E87 mileage Mileage
Tool option :Tacho Pro 2008 programmer

Modell 1er BMW (E87)

Use the board M35080 and clip smd8

Adjustment is done in 3 steps:
1. eeprom in instrument
2. CAS programming with BMW CAS connector
3. ErrorScan

Remove the instrument and open it
Look for the 8-pin chip M35080
( remove this chip)
connect the clip with port M35080.
Connect the clip to the chip M35080 (red to pin 1).
Select in theTacho Universal BMW ->1er->E87 -> M35080 clip
The Tacho Universal showns you the original km.
Save the data!!!
Go back to the menue BMW ->1er-> 35080-0 (erase) and wait until Tacho Universal
displays „OK“
Select BMW -> 1er-> 87-> M35080 clip
Load the original data you saved before and write it completely to the chip
Error message „data not equal“ can be ignored
Select BMW -> 1er->E87 -> M35080 clip and program the new km.
Do not install the instrument back yet! Before that, the CAS must be programmed
to “0”
Please follow the instructions carefully!!!

Connect the cluster connector from car to port A. (Pin1 to red)

Attention:
Before you pull a fuse,
remove the key and store it away from the car!
While programming, do not open or close any doors or touch any buttons!!!

Remove the small fuse. The fusebox is on the passengers side behind the glovebox. See picture.
Important: the small fuse stays removed during the complete process.
Connect the Can Dongle with the BMW CAS cable and the cluster connector in the car.
Select BMW -> 1er -> E87 -> Cas Prog
Follow exactly the instructions in Diga-Display, like „light on/off“
When it asks to „remove fuse“, the big fuse must be removed
I fit asks you to put it back, put back the big fuse
after programming is finished, put back the small fuse